|
These are our own custom designed- custom wired AWESOME quality pre-wired pickguard units. Go pick up a cheapo Strat from the local Guitar Barn and turn it into a vintage monster! This is NOT a pickguard unit pulled from a low-end Saga kit, or removed from a cheap Chinese Strat copy. High end stuff here. Wired with Full Sized Alpha Potentiometers, staggered vintage toned pickups, and a nice deep White Pearloid pickguard. Try and figure out what it would cost to wire one of these up for yourself? This is a great opportunity to grab one of these for what the big guitar makers pay- A similar Pickguard/Pickup/Pot/Switch/Knob setup is supplied to a "Very Famous" manufacturer, and I buy mine from the same source in stupid quantities. The pickups are nice, full ceramic bar magnet units with staggered pole pieces. It's got a real 5-way switch, smooth Full Sized Alpha audio taper pots and the full compliment of knobs and switch tip. This is a standard 11-hole Strat style pickguard, and should be a good fit for most Strat guitars. You might find a few holes off a bit, but after 25 years of fitting pickguards I can tell you- nearly every guitar needs a little bit of fitting work. Since the guard covers any relocated holes the finished product looks 100% Factory! I've installed like a million of these in kit guitars, as replacement for cheapo pickup combos on imports, and even in real Fender guitars with dead pickups. A great looking, great sounding rig ready for just that little touch of solder to get rocking! This is a very authentic looking and sounding rig- Super syrupy Strat tones! Last time I checked the big catalogs were getting $90 for a similar unit. I have one of these rigs on a beat old cheapo body with an Allparts neck- everyone raves about the tone...
|
