A MAJOR guitar factory was left with thousands of these- we had them finished off and will sell them to you at an unheard of price!The Ultimate for Sustain, Tone and Upper Fret Access!GLUED-IN setneck Strat style guitar. 21 medium jumbo frets. 12" radius with a medium "C" neck profile with just the hint of a deeper V. These are 43mm wide at the nut and 56mm wide at the heel. Super nice neck profile! Canadian HARD ROCK Maple neck with Rosewood fingerboard. Nice lightweight Pauwlonia body with clear white maple veneer. A high gloss finish has been applied and buffed to a gloss.This version is the traditional Strat-Style body but with a TWIST! The spaces for three traditional single coils has been routed from the TOP, and the control cavity routed from the REAR. Makes for a really sleek modern look. They are a full 43mm thick at the trem cavity and accept all of our Import Spec trems. The pickup wiring holes have been drilled, holes for volume and tone have been drilled, output jack hole has been drilled- even rear covers have been pre-installed at NO CHARGE! The only things you need to do are drill the two holes to mount your 3 or 5 way switch and, if using passive pickups, drill a hole through the cavity for a tremolo ground wire.We strongly recommend doing a standard fret level, grind and polish on ANY brand new project. These are brand new, unused... but do expect just the smallest amount of finish issues with these- they have not yet been assembled and gone through the standard factory touch-up and buff process- YOU will have to do that. The Pauwlonia body meets the maple neck and is glued together- NO BOLTS. The super tight neck fit and internal tenon make for a terrifically strong necks joint. Due to the two different woods meeting- you'll find that the finish will eventually show "Witness Lines" at that seam. Does not mean the wood is cracked, just means they expand and contract at different rates.Average weight on these is around 6 lbs.