These are our own custom designed- custom wired AWESOME quality pre-wired pickguard units. Go pick up a cheapo Strat from the local Guitar Barn and turn it into a vintage monster! This is NOT a pickguard unit pulled from a low-end Saga kit, or removed from a cheap Chinese strat copy. High end stuff here. Wired with Full Sized Alpha Potentiometers, KILLER hot White PAF style pickup and two full ceramic bar magnet single coils, white hardware and a nice 3-Ply W/B/W pickguard. Try and figure out what it would cost to wire one of these up for yourself?
This is a great opportunity to grab one of these for what the big guitar makers pay- A similar Pickguard/Pickup/Pot/Switch/Knob setup is supplied to a "Very Famous" manufacturer, and I buy mine from the same source in stupid quantities.
It's got a real 3-way switch, smooth Full Sized Alpha audio taper pots and the full compliment of knobs and switch tip. This is a standard 11-hole Strat style pickguard, and should be a good fit for most real Strat guitars. Most modern guitars have the H-S-H route or even the "Swimming Pool" route- if not- break out the chisels! You might find a few holes off a bit, but after 25 years of fitting pickguards I can tell you- nearly every guitar needs a little bit of fitting work.
I've installed like a million of these in kit guitars, as replacement for cheapo pickup combos on imports, and even in real Fender® guitars with dead pickups. A great looking, great sounding rig ready for just that little touch of solder to get rocking! This is a very authentic looking and sounding rig- Super syrupy Strat tones!
Remember- 3 ply- White/Black/White - not cheapo single ply white. Last time I checked the big catalogs were getting $100 for a similar unit. I have one of these rigs on a beat old cheapo body with an Allparts neck- everyone raves about the tone...
As with all of my items, this is a brand new, factory fresh unit. I DO NOT disassemble guitars, pawn off used parts as new, or sell parts from the big catalog distributors.